Service

Good Hardware, Torqued Right, Lasts for Years

Tools You Will Need

Torque Settings That Matter

Over-tightening is the most common mistake. A lag screw driven too hard strips the wood and loses most of its grip, while an under-tightened bolt lets the mount vibrate loose. As a rule, seat roof lags to roughly 10-14 Nm (7-10 ft-lb) into solid decking or rafters — firm enough to hold, never hard enough to spin. For bracket-to-pole bolts, snug to about 8-10 Nm (6-7 ft-lb) and re-check after the first storm. Always follow the torque printed on your specific bracket, and re-torque after a month of exposure.

Anchor Into Structure, Not Just Siding

Every fastener must bite into a rafter, stud or solid masonry — never into sheathing or siding alone. Use a stud finder to locate framing before you drill, and pre-drill pilot holes slightly smaller than the screw's shank. For masonry walls, use expanding anchors or epoxy-set bolts rather than plastic plugs, which crack and pull out under wind load.

Safety on Roofs and Ladders

Work on a dry, calm day and never on a wet or icy surface. Use a harness tied to a solid anchor when working on a pitched roof, and keep ladders on level ground with someone footing them. Route all power tools carefully so cords never cross your climbing path, and keep one hand on the ladder at all times when carrying hardware up or down.

Seal Every Penetration

After the mount is torqued and level, seal every hole with outdoor roofing sealant and install flashing under the shingle course above the bracket. A generous bead around each lag head stops water from following the screw into the deck. Check the mount six months later — re-torque anything that has loosened and refresh sealant that has cracked in the sun.

Recommended Accessories

For brackets, flashing and cable-entry hardware, see the XLinkCore mounting solutions range. Finish the install with a Standard 4 or Standard 4X cable and a power kit built for a clean, weather-tight run.

Engineered by Shenzhen XLinkCore Network Accessories Co., Ltd. — Starlink-compatible accessories that keep you connected anywhere.