| Factor | Wall Mount | Roof Mount |
|---|---|---|
| Installation difficulty | Easy | Moderate |
| Roof penetration needed | No | Yes |
| Sky view quality | Good (depends on wall orientation) | Excellent (unobstructed) |
| Leak risk | Low (only cable entry) | Moderate (mount + cable entry) |
| Signal obstructions | Higher (building may block angles) | Minimal |
| Wind exposure | Lower (building shelter) | Higher (fully exposed) |
| Aesthetic impact | Low (discreet on wall) | Visible from above |
| Rental-friendly | Yes (minimal damage) | No (permanent modification) |
| Installation time | 20-30 min | 45-60 min |
| Typical cost (mount only) | $39 - $59 | $49 - $129 |
| Wall Type | Hardware | Max Wind Load |
|---|---|---|
| Wood siding | Lag bolts into studs (16 inch centers) | 100 mph |
| Brick / Masonry | Sleeve anchors or wedge bolts | 90 mph |
| Stucco / EIFS | Toggle bolts + sealant at penetration | 80 mph |
| Vinyl siding | Must mount through siding into sheathing | 85 mph |
| Roof Type | Mounting Method | Max Wind Load |
|---|---|---|
| Asphalt shingle | Galvanized lag bolts + roofing sealant | 100 mph |
| Metal standing seam | Clamp mount (no penetration) | 100 mph |
| Flat membrane (TPO/EPDM) | Sealed bolt + rubber gasket | 90 mph |
| Tile / Slate | Tile hook or replacement tile | 110 mph |
Situation: A family of 4 wanted Starlink Standard for home internet. The north-facing wall was blocked by a large oak tree. The south-facing wall had clear sky view but required drilling through brick.
Solution: Wall mount on the south-facing brick wall with masonry anchors. Cable entered through an existing dryer vent opening. Total installation time: 35 minutes. Signal quality: Excellent, 250 Mbps average download.
Situation: Off-grid cabin with Starlink Mini powered by solar. Needed a mount that could survive heavy snow loads.
Solution: Roof mount using standing seam clamps (no penetration) on the metal roof. The elevated position kept the dish above snow accumulation. Cable entered through a roof vent boot. Total cost: $79 (mount only).
Situation: Renter needed temporary Starlink Mini installation without damaging the apartment.
Solution: Wall mount on the balcony railing using our Universal Pipe Mount adapter (no drilling required). Cable routed through a window gap using a flat cable adapter. Removed when moving out with no damage to the apartment.
A: Under FCC rules (OTARD, 47 CFR 1.4000), homeowners cannot be unreasonably restricted from installing satellite antennas on property they control. HOAs can impose reasonable restrictions for safety or historic preservation but cannot outright prohibit installation. Check your HOA rules and reference FCC OTARD if challenged.
A: Yes. The same Starlink terminal can be moved between mounts. Our mounts use standard bolt patterns, so you can unscrew the terminal from one mount and attach it to another in minutes.
Wall mounts, roof mounts, and adapters for every home installation scenario.
Email: ceo@xlinkcore.com
XLinkCore Network Accessories oferuje pełen zakres uchwytów, kabli i rozwiązań zasilających do Starlink, zaprojektowanych pod kątem zastosowań morskich, w pojazdach kempingowych (RV), przemysłowych i poza siecią. Skontaktuj się z naszym zespołem w sprawie zamówień hurtowych lub niestandardowych rozwiązań OEM/ODM.
Skontaktuj się z namiZaprojektowane przez Shenzhen XLinkCore Network Accessories Co., Ltd. – akcesoria kompatybilne ze Starlink, które utrzymują Cię w łączności w dowolnym miejscu.
